Introduction to Product

Dry type air core series reactor is suitable for 6,10,35kv power system, which is connected in series with shunt
capacitor to restrain the distortion of grid voltage waveform, so as to change the quality of power grid and ensure
the safe operation of power system; to restrain the harmonic current flowing through the capacitor bank and limit
the closing inrush current, so as to protect the capacitor and make it operate safely and reliably.

Dry type air core series reactor is suitable for 6,10,35kv power system, which is connected in series with shunt
capacitor to restrain the distortion of grid voltage waveform, so as to change the quality of power grid and ensure
the safe operation of power system; to restrain the harmonic current flowing through the capacitor bank and limit
the closing inrush current, so as to protect the capacitor and make it operate safely and reliably.

Feature:

1. The reactor adopts dry air core structure to avoid oil leakage, flammability and other defects of oil immersed
    reactor. It has simple maintenance, safe operation, no iron core, no ferromagnetic saturation, inductance value
    will not change with current change, good linearity and low noise.

2. The reactor coil is encapsulated by epoxy resin impregnated weft free glass ribbon. The reactor coil adopts
    polyester film and glass fiber with excellent insulation performance as the turn to turn insulation of conductor.

3. The surface of reactor is covered with silicon organic paint which is resistant to ultraviolet radiation, which has
    good outdoor weather resistance performance.

4. Polyester glass pull-out rod is used as axial cooling air passage for reactor, which has good heat dissipation
    performance.

5.The maximum temperature of the reactor is taken into account to ensure the safety of the reactor during long-term
    operation.

6. Because the reactor adopts multi-layer parallel structure, the axial electric stress of the coil is zero, and the voltage
    distribution along the coil axial height direction is uniform under steady-state operating voltage.

7. Since the reactor is wrapped with non weft glass ribbon impregnated with epoxy resin, the coil has good integrity
    after curing treatment, and the noise level of reactor is lower than 60dB during the whole service life.

8. The reactor adopts aluminum conductor (Φ 1.5 ~ Φ 5) with small cross section as coil conductor, which effectively
    reduces eddy current loss in the conductor under harmonic state.

9. Because the reactor is wrapped with epoxy resin impregnated weft free glass ribbon, the huge mechanical force
    generated when the reactor passes through the short circuit current is borne by the enveloping, so that the whole
    coil has a very high ability to resist short circuit current.

10. The conductive part of reactor is welded by argon arc welding, and there are no fastening parts on the mechanical
      structure, which greatly improves the operation reliability.

11. The whole reactor has a simple and compact structure and can operate for a long time under outdoor climate
      conditions without equipment maintenance requirements.

Technical specification:

Please provide below parameters while ordering:

1. Rated frequency;

2. System voltage;

3. Rated capacity of matching capacitor bank;

4. Rated voltage of matching capacitor;

5. Rated reactance or reactance rate of reactor;

6. Insulation level;

7. Insulation heat resistance grade;

8. Place of use: indoor or outdoor;

9. Installation mode and angle of incoming and outgoing lines;

10. Other special requirements.

Using environment:

1. Place of use: outdoor or indoor, indoor use should pay attention to ventilation and heat dissipation.

2. Ambient temperature: - 40 ~ 45 ºC.

3. Relative humidity: monthly average not more than 90%, daily average not more than 95%.

4. Maximum wind speed: no more than 30m / s.

5. Altitude: no more than 1000m (more than 1000m shall be stated when ordering).

6. Seismic capacity: it can withstand earthquakes with intensity of 8.

7. There should be no severe vibration or turbulence in the installation and operation area.

8. The installation and operation area shall be free of harmful gas, steam, conductive or explosive dust.

(if there are special requirements, please indicate when ordering.)

Why Choose Us

FIRST-CLASS PROCESSING AND TEST EQUIPMENT
We have more than 500 sets of sophisticated, advance production and test equipments, complete and perfect processing 
equipments, and scientific and rational processing technology, which guarantee first-class products, Authorized by the
Bureau of Zhejiang Technology Supervision, Quzhou Fangyuan Inspection Company of Power Transmission and
Transformation Equipment, whick is based on our testing center, undertakes the quality inspection of the industry in our
province, this is a solid guarantee for our excellent product quality.

BEAUTIFUL ENVIRONMENT
We are confident that good products come from good personnel, and good environment makes qualified personnel. The
company is committed to creating a garden-like working environment for employees. We have green belts, modern
standardized workshops and well-planned parks where we sow our youth; we work hard, so we are harvesting the future.

With the first-class quality products, reasonable price and excellent after-sale services.product not only best-selling all
over the country,but also in the international market have higher credit, such as Thailand, Vietnam, Myanmar, Indonesia,
alaysia,Philippines, Ethiopia and Nigeria, Saxonstan, Uzbekistan, Korea, Turkey, Sudan, Iran etc. especially in the steel
enterprises, VILLE production of transformers already have high reputation.