Reactor for automobile and charging pile

Product introduction:

1.The reactor is single phase and the iron core is dry.
2. The iron core is made of a square shape,a cylinder shape,a magnetic powder core or an amorphous iron
  core,and the air gap is evenly distributed inside the magnetic powder core,which reduces the loss and reduces
   the total noise.

3.Reactor design of low magnetic flux density,good linearity,strong overload capacity.

4.After the reactor coil and the iron core are assembled into a whole,the reactor coil and the iron core are firmly
   integrated into a whole,and the noise of the running time is greatly reduced.

5.Compared with the similar products in China,the reactor has the advantages of beautiful appearance and the
   like can replaced the well-known brands at home and abroad.
 

Use environment:
Not more than 2000 meters above the sea level.Operating ambient temperature -25ºC~60ºC,the relative
humidity is not more than 90%.No toxic gas around,no inflammable and explosive articles.Surrounding
environment should have good ventilation conditions,such as installed in the cabinet,should be the installation
of ventilation equipment.

Product use:
Single-phase AC reactor with a charging pile three-phase PWM rectifier,single-phase DC reactor for charging
the DC side of the charging pile

Technical parameter:
Input rated voltage:220V-1200V
Operating frequency:50/60HZ
Rated operating current:1A-500A
Anti electric strength:iron core winding
1)3000VAC/50Hz/5Ma/10s
2)No arcing breakdown.
Insulation resistance:1000VDC insulation resistance is greater than or equal to 100M≥100MΩ
Reactor noise:less than 65 Db(1 meter test with reactor level)
Protection level:IP00
Insulation class:H level or above
Efficiency:to meet the requirements of high efficiency active filter system

Product implementation standard:
IEC289:1987 reactor GB1022988 reactor eqvIEC289:1987 JB9644-1999 semiconductor electric drive
reactor.GB7328-1987 transformer and reactor level determination.